HP Officejet J5730 - Load full-size paper

To load full-size paper

1.

Remove the output tray.

2.

Slide the paper-width guide to its outermost position.

3.

Tap a stack of paper on a flat surface to align the edges, and then check the paper
for the following:
•

Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

•

Make sure all the paper in the stack is the same size and type.

Chapter 5

64

Load originals and load paper

4.

Insert the stack of paper into the input tray with the short edge forward and the print
side down. Slide the stack of paper forward until it stops.

CAUTION:

Make sure that the HP All-in-One is idle and silent when you load

paper into the input tray. If the HP All-in-One is servicing the print cartridges or
otherwise engaged in a task, the paper stop inside the device might not be in
place. You could push the paper too far forward, causing the HP All-in-One to
eject blank pages.

TIP:

If you are using letterhead, insert the top of the page first with the print side

down. For more help on loading full-size paper and letterhead, refer to the diagram
engraved in the base of the input tray.

5.

Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.

6.

Replace the output tray.

Load paper

65